Refurbish LED Sign on Existing Monument

Current Sign

Lightbox 1 foot high and 7 feet wide; LED sign that has reached end of life, approximately 3 feet by 6 feet.

The existing LED sign (approximately 3 ft × 8 ft) has reached the end of its life, mounted below a 1 ft × 8 ft lightbox on the monument.

Site Image

Bettendorf, IA

Aerial view of the location showing the monument on the church property, the road, and visibility.

Aerial view showing the monument's position on the church property relative to the road and visibility.

Previous Inside View

The existing front-servicing sign opens like a car bonnet from the bottom, showing how it is serviced.

The existing sign is front-servicing

Angle View

Side view of the monument with the broken side cover on the lightbox.

Side view of the monument

Vantage View

Vantage view of the sign from the road, as seen by commuters.

Vantage view showing how the sign is seen from the road by commuters.

Proposed Frame 01

Refurbishing the old sign with a new one. The side cover will need to be adjusted to accommodate the new sign dimensions, and the perimeter around the sign on the monument will be covered for a clean finish.
D

Frame measurements 1

Proposed sign measurements. Refurbishing the old sign with a new one will require the side cover to be adjusted to accommodate the new sign dimensions. The perimeter around the sign on the monument will be covered for a clean finish.
Frame measurements 2
Side view.

Rendered View

3D rendered view showing the monument with the old sign removed. Shows the existing sign cavity with a tubular frame across the cavity (top, bottom, and between the gap) with two vertical bars in the middle of the cavity, parallel, to support the sign on the monument.
Proposal 01 uses a tubular frame across the existing sign cavity — top, bottom, and across the gap — with two parallel vertical support bars in the middle of the cavity to support the new sign on the monument
Installed view with the new LED sign and the old lightbox.

.

 Exploded View

Exploded view showing how the new LED sign mounts to the monument, with horizontal angle irons on the top and bottom of the old LED sign cavity to accommodate the mounting of the new sign.

Exploded view showing how the new LED sign mounts to the monument using horizontal angle irons on the top and bottom of the existing cavity.

Proposed Frame 02

Proposed Sign 02 layout.

 Rendered View

Rendered view of the horizontal angle iron stretching all the way to the columns on each side of the LED sign, fixed to the monument.
Proposal 02 uses horizontal angle irons that stretch all the way to the columns on each side of the LED sign, fixed to the monument for support.

Proposed Sign 02 installed view.

 Exploded View

Proposed Sign 02 exploded view.

Project Scope — Bid Required

Please submit an itemized bid covering the complete scope below. Please provide separate quotes for both Proposal 01 and Proposal 02, so we can compare which approach is more viable and cost-effective.

  • Fabricate the support frame — tubular and angular — to mount the new LED sign to the existing monument (per the applicable proposal).
  • Fabricate a shroud to cover any gap on the monument created by the new sign.
  • Fabricate a side cover for the lightbox.

Not included in scope:

  • LED sign supply
  • Software programming and support
  • Electrical work — final termination, new circuits, feeders, or trenching (to be handled by a licensed electrician)

Terms & Conditions

Terms and conditions apply. Please review the full installer guidelines before proceeding: LED Sign City – Guidelines for Third-Party Installers

Svg Vector Icons : http://www.onlinewebfonts.com/icon
We Value Your Privacy We use cookies to improve your experience, deliver personalized content, serve relevant ads, and analyze our traffic. By selecting "Accept All," you agree to the use of all cookies." For more information, see our Cookie Policy
Accept All Deny
You have successfully subscribed!
This email has been registered