Discussion for Mounting the LED Sign to the Monument

Classic Brick Enclosure (Color Code: Fried Brick)

When mounting an LED sign to a monument, it is important to consider various factors. For example, a 4x6 LED sign (dimensions: 4.2 feet x 6.3 feet or 37.8 inches x 75.6 inches) serves as a reference for these guidelines:

1. Width and Height of the LED Sign

• Width: 6.3 feet (75.6 inches)

• Height: 4.2 feet (37.8 inches)

2. Setback Requirements

• The thickness of the sign is 3.4 inches.

• The connector plug at the back is 4.2 inches, requiring a total setback of 7.6 inches to accommodate the flex of the cables.

• Depending on how flush the screen will be to the mounting surface, this setback must be factored into the design.

3. Mount Points

The mounting points for the sign follow a specific pattern:

• The first mount point starts 1.18 inches from the edge of the sign.

• The next mount point is 10.24 inches to the left.

• The subsequent mount point is 2.36 inches from the next edge (factoring in the edge of each cabinet connecting together).

• The pattern continues across and down the entire sign until the final mount point, which is again 1.18 inches from the edge.

While each cabinet typically creates four mounting points, it is common to use only 4 to 6 mounting points for the entire sign. The installer can select points most suitable for their specific installation, often prioritizing those along the edges for stability. However, additional points are available for flexibility, accommodating various mounting needs.

4. Outlets for Components

• The outlets required include:

  • Power cable connectors: 1.5 inches in diameter at their widest point.

  • Ethernet connectors: Connects to the antenna and may be pulled through the same conduit as the power cables to reduce the need for additional holes.

5. Brightness Sensor

• The brightness sensor uses the same connector type as the power cables.

• The sensor itself can be separated for installation, allowing one end to be placed inside and the other outside. It can be either screwed in or threaded into place.

Recommendations for Installation

1. Pre-Mounting Preparations:

   • Connect cables and adapters prior to mounting to simplify installation.

   • Ensure adequate space for conduit runs to accommodate both power and Ethernet cables.

2. Hole Placement:

   • Smaller holes can be made specifically for the Ethernet adapter.

   • Conduit holes for power cables should align with the pre-setback measurements.

3. Sensor Placement:

   • Separate the brightness sensor into its two components.

   • Position the external sensor in an unobstructed area for accurate brightness detection.

Visual Context

• To enhance understanding, illustrations can be provided for:

  • Mount point layout: Depicting the pattern and spacing.

  • Setback requirements: Showing the 7.6-inch space needed for the sign and connectors.

  • Cable and sensor installation: Highlighting suggested configurations for power and Ethernet cables, as well as the brightness sensor placement.

This structured approach ensures precise and effective mounting, facilitating both the physical installation and operational functionality of the LED sign.

Materials