2ft by 7ft LED Sign and Lightbox Installation in Cleburne, TX

1) Project Summary

Install a double-sided outdoor LED sign and an internally illuminated lightbox. on the existing poles

Resolution:	80 pixels tall × 280 pixels wide
Power Requirements:	12.1 AMPS @ 110V or 6.0 AMPS @ 220V / Side
Weight:	~140 lbs per side (approximately 280 lbs for the double-sided sign)

Proposed sign: new lightbox with church name and logo, with LED sign below

Proposed Sign 01

Proposed Sign 02

Proposed Sign 03

Proposed Sign 04

Lightbox measurement
Measurements for the lightbox and the font size of the church name.

Current Sign

Unlit static sign on two thin metal poles with the church name, on the curb by the road, showing the church schedule

Site Image

Aerial map of the sign location on the property by the road

Click here to review the Wiring Diagram

One dedicated 20-amp circuit at 110V per side. Circuits must not be shared and must not be on a timer.
An indoor disconnect switch is recommended to allow power to be safely cut in the event of an emergency or extreme weather.
The power connection point should be within 1 foot of the sign to accommodate the sign's onboard cables. Running power to that point — whether from a breaker panel, conduit, or junction box — is outside the scope of installation and should be handled by a licensed electrician.