Installer Illustration — Preliminary Mounting Concept
This illustration set shows (1) the intended finished result and (2) two possible mounting methods based on limited information. Final method depends on verifying what structural support exists behind the brick.
Concept 1 — Finished Result (Target Outcome)
LED sign mounted externally on the brick structure. This is the intended final appearance and sign position.
LED sign mounted externally on the brick structure. This is the intended final appearance and sign position.
Concept 2 — Method A (Hypothetical)
If a pole/steel member exists behind the brick, angle iron could be secured to that internal support. This may require selective brick removal for access and bolting/welding to the structural member.
If a pole/steel member exists behind the brick, angle iron could be secured to that internal support. This may require selective brick removal for access and bolting/welding to the structural member.
Concept 2 — Method B (Conditional)
Alternate approach using anchor/support points between the columns. Feasibility depends on available framing/material behind the brick and whether through-fastening is possible without compromising the façade.
Alternate approach using anchor/support points between the columns. Feasibility depends on available framing/material behind the brick and whether through-fastening is possible without compromising the façade.
Still unclear (requires verification)
- What structure exists behind the brick (steel pole, tube steel, framing, or none).
- How the existing sign was anchored to the structure (what framing/brackets were used and how they were secured).
- Access constraints for through-bolting or welding (and whether brick removal is acceptable).
- Final bracket sizing/steel requirements pending structural confirmation.