Gas Price Sign: How to Change the Prices

This guide will walk you through updating the price on your LED gas price sign using the remote control.

Table of Contents

1. Introduction
2. Powering On the Remote
3. Navigating to the Fuel Price Page
4. Setting the Price
5. Saving and Sending the New Price

1. Introduction

This guide provides a step-by-step process to change the fuel price displayed on your LED sign. Please ensure your sign is powered on before following these steps. If you haven’t tested the power, visit Gas Price Sign: How to connect your power supply for setup instructions.

2. Powering On the Remote

1. To turn on the remote, press and hold the Right Arrow button.
2. This will activate the remote, allowing you to proceed with the price change.

3. Navigating to the Fuel Price Page

1. With the remote powered on, press the Right Arrow again to navigate to the Fuel Price Page.
2. Once on this page, press OK to confirm.

4. Setting the Price

1. Use the Up and Down Arrows on the remote to adjust each digit of the price:

   • Up Arrow increases the number.
   • Down Arrow decreases the number.

2. Use the Left and Right Arrows to move between digits.

   Example: To set the price to $3.00:

   • Adjust the first digit to 3 using the up/down arrows.
   • Use the Right Arrow to move to the cents digits, setting them to 00 as needed.

5. Saving and Sending the New Price

1. After setting the price, press the Left Arrow to send the new price to the sign.
2. Your sign will update immediately to display the new price.